What is the general reason for the phenomenon of jumping when using an electronic ruler?

1、When using an electronic ruler, the power supply should have sufficient capacity. If the power supply capacity is too small, the mold closing motion will cause the display of the electronic ruler to jump, and the glue melting motion will also cause the display of the electronic ruler to fluctuate.

2、The driving power of the solenoid valve is connected to the electronic scale. When the power supply is connected together, it is easy to experience jumping. In severe cases, voltage fluctuations can be measured using the voltage range of a multimeter.

3、Even after excluding static interference, high-frequency interference, and poor neutrality, the problem cannot be solved, and it can also be concluded that the power supply is too low.

The above situations are the common reasons for jumping when using an electronic ruler. Users can suggest troubleshooting them one by one based on these points. If the problem cannot be solved, you can also contact our manufacturer!