Magnet Resistive Displacement Sensor: PME12
Technical Parameters
Effective electrical travel(C.E.U) | 50~1000mm |
independent linearity(in C.E.U.) | 0.05% |
Displacement efficiency | ≤5m/s |
Greater acceleration | ≤10m/s² |
DIN vibration IEC 68T2-6 | 12g,10...2000Hz |
Pointer resistance | ≤0.5N |
Impact test DIN IEC68T2-27 | 50g,11ms,click |
Displacement sensitivity (without hysteresis) | 0.05~0.1mm |
Resistance tolerance | ±10% |
Recommended pointer current | <0.1uA |
Larger pointer current, under poor performance conditions | 10mA |
Greater application voltage | 36V |
Dielectric Strength | >100MΩ当500V=,1bar,2s |
Dielectric Strength | <100uA当500V=,50Hz,2s,1bar |
Runs | 一亿次 |
Environmental protection level | IP67 |
Actual temperature coefficient of output voltage | <1.5ppm/℃ |
Working temperature range | -40...+120℃ |
Storage temperature range | -50...+150℃ |
Install Dimension:
Main features:
The PME12 linear displacement sensor adopts an unobstructed shaft design and a sealing grade of IP67, which can meet the displacement measurement needs in dusty or oily environments, humid environments, or temporary immersion conditions.
The PME series products are a new type of displacement measurement sensor based on the connection between external electromagnetic actuators and internal measuring verniers.
By replacing the resistance axis in traditional displacement sensors with a magnetic cursor, the sensor structure is more compact.
After exceeding the theoretical electrical stroke, there is no electrical signal change, making installation simpler.
After exceeding the theoretical electrical stroke, there is no electrical signal change, making installation simpler. This system sensor is suitable for displacement measurement in various air pressure environments, with a working pressure of ≤ 2 5MPa.
Range selection:50mm-1000mm is optional(mm):
50 | 100 | 150 | 200 | 250 | 300 | 350 | 400 | 450 | 500 | 550 | 600 | 650 | 700 | 750 | 800 | 850 | 900 | 950 | 1000 |
important reminder: The data reported in the table of contents, including straight lines and temperature coefficients, are only valid for metric devices with a larger flow rate of ≤ 10uA through the pointer circuit IC