LPS-L Pull wire displacement sensor:
Pull wire displacement sensor, also known as pull wire encoder, pull wire rule, pull wire encoder, pull wire displacement sensor. It is the exquisite integration of linear displacement sensor in structure. Fully combining the advantages of angle sensor and linear displacement sensor, becoming an excellent sensor with compact structure,measuring stroke and high precision measurement.
Pull wire displacement sensor series products have a lot of choices meansuring range from 100mm to 10,000mm. Output signal have:Analog output signal 4-20mA, 0-5V, 0-10V and pulse output signal A, B, Z phase output, digital output signal RS485 can meet the needs of large stroke, high precision and various signal request.
The instantaneous acceleration of the reciprocating motion of the S size and M size series products shall not exceed 1 M/S. The instantaneous acceleration of the reciprocating motion of L stand and XL stand series products shall not exceed 0.5 m/s. Otherwise, the cable will break.
LPS-L Pull wire displacement sensorn technical parameter:
Specification of items | Details | Remarks |
Measuring range | 4500mm-10000mm | Other range can be customized |
Supply voltage | DC 5V～DC 10V（Resistance output type） DC12V～DC24V（voltage/current/RS485） | Fluctuation of less than 5% |
Supply current | 10mA～35mA | |
Output signal | Resistance output type: 0-10kΩ, Voltage output type: 0-5V, 0-10V, Current output type: 4-20mA (2-wire / 3-wire / 4-wire) Digital signal output: RS485, Pulse output type: A B Z
| |
Independent Linearity | ±0.25%FS～±0.3%FS | |
repeatability | ±0.05%FS | |
Measurement Wire | 0.8mm or 1.5mm(SUS304) | |
Working environment temperature | -10℃～65℃ | |
Vibration | 10Hz to 2000Hz | |
Protection class | IP65 |
LPS-L Pull wire displacement sensor wiring connection：
LPS-L Pull wire displacent sensor installation dimension：
LPS-L Pull wire displacement sensor model selection：
1.The use of the bottom 4 fixing screw holes, according to the site and machine installation space facilities need, direct installation or additional protection or other mechanical use.
2. Stainless steel cable installation, must pay attention to the horizontal Angle, that is, as far as possible to make the cable from the outlet to the moving part of the mechanism, the horizontal slide during work.
3. Keep a small Angle (allowable deviation +/-3°) to ensure measurement accuracy and cable life.
The steel cable body is stainless steel and coated with fluorine layer, do not let it be hurt by external forces, burn, impact and other improper things: excessive dust, debris accumulation or enough to damage the steel cable stored in the internal pulley or wire outlet will cause damage to the steel cable, resulting in failure of operation.
4. Not installed in the workbench or fixed sitting, do not use hands or other products to pull out the steel cable and let it bounce back instantaneously. This will cause the cable to break and damage the body structure.
5. If used in the non-linear movement of the mechanism, please install the appropriate pulley operation.
6. If used in bad environment or special occasions, please install your own protection mechanism.