XSAEW Potentiometer  Digital Display Instrument
Paired with resistor scale and potentiometer. (replaces original XSAE)
Single 6-digit LED display, display range is -99999~99999
According to the characteristics of the resistor scale (potentiometer), the input circuit has been optimized
The display and measurement stability are improved, and the ability to resist electromagnetic interference and serial mode interference is improved.
0.05 level accuracy, measurement and control speed can be set 5-200 times per second, display range -99999~99999
Panel buttons and switch input setting function
10-point polyline correction function

Optional 1~4 points alarm output. It includes six basic alarm modes: upper limit of measured value, lower limit of measured value, upper limit of deviation, lower limit of deviation, upper limit of absolute value of deviation, lower limit of absolute value of deviation, four standby alarm modes of upper and lower standby limits, upper and lower standby deviation limits, and one input fault
alarm mode. .

(Standby alarm mode: means that the instrument will not alarm even if it is in the alarm area when the power is on. When the measured value enters the non-alarm area, the standby condition will be established, and then the alarm will be normal.)

content

Code description

XSAEW-

0.05 level measurement accuracy; Single display

Dimension

AH

160×80×125      Hole Size:152×76

CH

96×48×82       Hole Size：92×45

Panel specifications

6 digit LED, display range-99999 to 99999

Signal input(Other input singals instructions when ordering)

W

potentiometer（500Ω～10kΩ）

Contact input (optional)

K1

1 point external switch input for zeroing.(When AH and CH select K, communication and transmission can only choose one option; E size does not support K option)

Alarm（option）(250V AC/3A,resistive load)

AH

T1～T4

1~4 point relay output, are normally open and closed double contacts

CH

T1～T2

1~2 point relay output, are normally open and closed double contacts

T3

3 point relay output is a single open contact.

Transmitting (optional) (resolution: 1/3000; load capacity: 600Ω）

A1

Current output（4-20）mA、（0-10）mA、（0-20）mA

A2

Voltage output（1-5）V、（0-5）V

A3

Voltage output（0-10）V

Communication (optional) (Photoelectric isolation)

MS1

The RS232 interface can select the TCASCII or Modbus-RTU through the software settings

MS2

The RS485 interface can select the TCASCII or Modbus-RTU through the software settings

Power Specifications

V0

100-240V AC 50/60 Hz

V1

10-24VAC 50/60Hz；10-24VDC